Photography for beginners

f/stop

There are three aspects to exposure control in digital photography:-

  • Amount of light - controlled by aperture
  • Amount of light - controlled by exposure time
  • Sensitivity of recording - controlled by ISO

These are inter-related, so as one increases, another one has to decrease to get the same results.  We will have a topic devoted to this later but for now I will just define the technical aspects of f-stop or focal ratio.  It does cause some confusion for beginners because, perversely small numbers mean more light, large numbers mean less light.   I'll try and explain how this comes about.

The amount of light getting in to the camera is controlled by the width of the hole that lets the light in, which is called the aperture, which is just a fancy name for a hole.  So if you have a hole that is 25mm in diameter it lets in 4 times as much light as a hole that is 12.5mm wide.  The reason it is four times and not two times is because it is a square law, i.e. twice as tall AND twice as wide.  If you have got lost on the mathematics here, forget about how much and just remember wide hole - small number - more light.

Now they could have just measured aperture in milli-metres and it would have been very simple.  However they chose to relate the aperture to the focal length and call it the focal ratio.  Moreover they chose to divide the aperture by the focal length which gives us a fraction which is why we have that oblique line, the symbol for division, and that is why the numbers seem to go the wrong way, (smaller is brighter).  So an aperture of 25mm with a focal length of 50mm gives us an f-stop of f/2, and an aperture of 12.5mm with a focal length of 50mm gives us an f-stop of f/4.  By relating the aperture to the focal length, it has the effect that f/2.8 on a wide angle lens gives the same exposure as f/2.8 on a telephoto lens.  If we denoted aperture as physical width it would need resetting as we zoom.  The width does need changing but the lens does this for us and the f/stop remains the same.

Note that f/4 to f/2.8 is one f-stop and f/2.8 to f/2 is one f-stop.  Each f-stop either doubles or halves the light, depending on which way you are going.  Because doubling the aperture increases the exposure by four rather than two, f-stops have peculiar values that are multiples of the square root of two.  You can either just let these numbers wash over your head and ignore them, relying on your camera to tell you what exposure you need, or you can learn them so that you can then do exposure calculations in your head.  If you are tempted by the latter then this wikipedia article has tables of the values.  Full f-stops are not too bad, but it starts to get tricky when half and third f-stops are combined.

focus stacking

One of the problems with Macro photography is that because you are working close to the lens the depth of field is very limited.  With some subjects there is just sufficient depth, and a blurred background helps to make the subject stand out.  For other subjects however you just need a little greater depth of field.  Increasing the lighting and using a smaller aperture might help, but it gives only a small increase.  If you need three or four times the depth of field, then you can use the technique of focus stacking, where you take several images at increasing focal depths and merge them with a focus stacking program.  It is not a panacea and there are problems to overcome, but it is an interesting technique to experiment with.   It is obviously easier with still life than with live subjects.

Fovea, Fovea centralis.

A small region of the retina, in the center of the macula, where there is the highest density of light receptors which gives high accuity vision.

[ back to index --- back to glossary ]